ASSRA Forum › General › Gunsmithing Single Shot Rifles › Martini screw need
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Martini screw need (Read 597 times)
porchdog48
Full Member
***
Offline



Posts: 100
Location: Waynesburg, Ohio
Joined: Mar 25th, 2010
Martini screw need
Jun 4th, 2023 at 8:11pm
Print Post  
Taking a shot in the dark. I need the screw that retains the lever shaft. Any suggestions as to where I can find one would be greatly appreciated. 
Dave.
  
Back to top
 
IP Logged
 
fishoot
Full Member
***
Offline



Posts: 129
Location: Folsom, CA
Joined: Dec 29th, 2011
Re: Martini screw need
Reply #1 - Jun 5th, 2023 at 10:50am
Print Post  
Send me a PM.  There is a guy, Scott Stonehill, that makes custom screws.  He made one for me.  It was perfect! Wink
  
Back to top
 
IP Logged
 
lion
Full Member
***
Offline



Posts: 246
Joined: Feb 25th, 2012
Re: Martini screw need
Reply #2 - Jun 5th, 2023 at 10:54am
Print Post  
I have this but think it is the screw that goes into the lever pin.
  
Back to top
 
IP Logged
 
porchdog48
Full Member
***
Offline



Posts: 100
Location: Waynesburg, Ohio
Joined: Mar 25th, 2010
Re: Martini screw need
Reply #3 - Jun 5th, 2023 at 5:50pm
Print Post  
That looks like it should be correct. Head should be about .275 diameter and close to 4-40 thread. 
Dave
  
Back to top
 
IP Logged
 
MrTipUp
Frequent Elocutionist
*****
Offline


Quality is to a product
what character is to
a man

Posts: 1305
Location: Indiana
Joined: Feb 19th, 2020
Re: Martini screw need
Reply #4 - Jun 6th, 2023 at 5:37am
Print Post  
While I can also highly recommend Scott Stonehill, the following contact information for him is several years old:
4371 Lake Idylwilde Dr.
Evans, GA 30809
706-833-9048


Bill Lawrence
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.9177 seconds.