ASSRA Forum - Ballard extractor source(s) or prints

ASSRA Forum › General › Gunsmithing Single Shot Rifles › Ballard extractor source(s) or prints

(Moderator Group: Moderator)

‹ Previous Topic | Next Topic ›

Pages: 1

Ballard extractor source(s) or prints (Read 522 times)

bohemianway Oldtimer Offline Posts: 651 Location: Andover, MN Joined: Apr 16^th, 2004	Ballard extractor source(s) or prints Sep 1^st, 2022 at 5:47pm	Print Post
	Hey, I need a couple of center fire extractors for Ballards and wondering if anyone is selling them now that DistantThunder is no longer active building them. Or, if anyone could share a detailed drawing to save me (Lazy as I am) some time or tricks to making them ( I have a pretty complete machine shop). Thank you, Charles


	GTalk IP Logged

GT Frequent Elocutionist Offline Posts: 2152 Location: Northeast Wyoming Joined: Jun 28^th, 2015	Re: Ballard extractor source(s) or prints Reply #1 - Sep 2^nd, 2022 at 9:41am	Print Post
	Charles, The drawing looks busy and intimidating but like any other, it's a road map, pick a start point and move one step at a time. I like to begin at the drilled hole and move out. Rodney may have cast or waterjet blanks that will save a little time... Your's from scratch would be perfect I'd bet... Greg

	"To invent, you need a good imagination and a pile of junk" T. A. Edison "The trouble ain't that there is too many fools, but that the lightning ain't distributed right" M.T.
	IP Logged

marlinguy Frequent Elocutionist Offline Ballards may be weaker, but they sure are neater! Posts: 16878 Location: Oregon Joined: Feb 2^nd, 2009	Re: Ballard extractor source(s) or prints Reply #2 - Sep 2^nd, 2022 at 9:45am	Print Post
	The Rifle Shoppe in Oklahoma sells them as cast, and not hard to finish up. $20. (You need to *Login* or *Register* to view media files and links)

	(You need to *Login* or *Register* to view media files and links)
	IP Logged

Pages: 1

‹ Previous Topic | Next Topic ›

Page completed in 0.8720 seconds.