ASSRA Forum › General › Gunsmithing Single Shot Rifles › Ballard stock adaptation/inletting/fitting
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 ... 6 7 [8]  Send TopicPrint
Very Hot Topic (More than 25 Replies) Ballard stock adaptation/inletting/fitting (Read 14584 times)
ssdave
Frequent Elocutionist
*****
Offline



Posts: 1942
Location: Eastern Oregon
Joined: Apr 16th, 2004
Re: Ballard stock adaptation/inletting/fitting
Reply #105 - May 8th, 2025 at 12:51am
Print Post  
Finished the barrel today, 2 or 3 more rust/card cycles and it looks pretty good.  Always hard to tell when you should stop.  I stop when the finish is even and doesn't show any spotting or inconsistencies.

(You need to Login or Register to view media files and links)
(You need to Login or Register to view media files and links)
(You need to Login or Register to view media files and links)
  
Back to top
 
IP Logged
 
bobw
Frequent Elocutionist
*****
Offline



Posts: 1781
Location: NW, Iowa
Joined: Mar 19th, 2013
Re: Ballard stock adaptation/inletting/fitting
Reply #106 - May 8th, 2025 at 10:54am
Print Post  
Looks good Dave.  The transition is much nicer now that you reworked it.
Bob
  
Robert Warren
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 ... 6 7 [8] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2025. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.9297 seconds.