ASSRA Forum - short brass for breach seat OK?

ASSRA Forum › General › Reloading the Single Shot Rifle › short brass for breach seat OK?

(Moderator Group: Moderator)

‹ Previous Topic | Next Topic ›

Pages: 1

short brass for breach seat OK? (Read 414 times)

Joe_S Oldtimer Offline Posts: 996 Joined: Jun 29^th, 2004	short brass for breach seat OK? Jul 1^st, 2022 at 5:08pm	Print Post
	I am shooting a 38-55 with Starline brass, the long version, and I also have some of the short Win brass. I have been breach seating with both the long and short brass, (mostly long). Is there any disadvantage to shooting the short brass if I am breechseating? Not sure if there will be accelerated throat erosion or some other potential problem. Thanks! Joe S


	IP Logged

Green_Frog Frequent Elocutionist Offline "It ain't easy being green" ASSRA Life #281 Posts: 4029 Location: Lynchburg, VA Joined: Apr 18^th, 2004	Re: short brass for breach seat OK? Reply #1 - Jul 3^rd, 2022 at 8:10pm	Print Post
	A lot will depend on how deeply you have to breech seat the bullet to get a good seal. Start by breach seating a bullet as shallowly as possible and testing to see whether you have a solid seal by placing a primed case with no powder into the chamber. If you have a good seal, the case will pop out smartly after you pop the primer and reopen the action. There will be very little noise and the bullet will be well engraved. The actual seating depth needed depends on how soon the bullet seats complettely. Froggie


	IP Logged

Pages: 1

‹ Previous Topic | Next Topic ›

Page completed in 0.5303 seconds.