ASSRA Forum › General › Single Shot Rifles › H & R Trapdoor
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic H & R Trapdoor (Read 1866 times)
cpace
Participating Member
*
Offline



Posts: 15
Joined: May 26th, 2015
H & R Trapdoor
May 26th, 2022 at 3:43pm
Print Post  
I am interested in how well they shoot and loads for the Officers Model.
Thanks
Carney
  
Back to top
 
IP Logged
 
Cbashooter
Frequent Elocutionist
*****
Offline



Posts: 1608
Location: Eastern Wa.
Joined: Mar 31st, 2018
Re: H & R Trapdoor
Reply #1 - May 26th, 2022 at 3:47pm
Print Post  
cpace wrote on May 26th, 2022 at 3:43pm:
I am interested in how well they shoot and loads for the Officers Model.
Thanks
Carney


Mine was phenomenally accurate with the 457124 and 12g unique.  My friend now owns the gun and shoots the same load. 2 inch groups at 100 yd were not very hard . The only thing we did was added a detent under the set screw where where the latch went to the locking pivot as it kept loosening up and the action would automatically open.
  
Back to top
 
IP Logged
 
4570mike
Senior Forum Member
****
Offline



Posts: 445
Location: On the Peninsula
Joined: Apr 11th, 2013
Re: H & R Trapdoor
Reply #2 - May 28th, 2022 at 11:01am
Print Post  
I've had several of the H&R TD's. Sill have an Officer's Model and a Calvary Carbine.  Never had any issues with them.  My loads were always with BH209 and a 345 gr slug.  The load was good past 200 yds. and not too much recoil.
I had the Officer's Model fitted with a Lee Shaver Soule rear sight and Lyman 17A on the front; makes a very good target rifle.
I put a "dab" of Loc-Tite on the latch screw just to avoid any looseness there.
Mike.
  
Back to top
 
IP Logged
 
cpace
Participating Member
*
Offline



Posts: 15
Joined: May 26th, 2015
Re: H & R Trapdoor
Reply #3 - May 29th, 2022 at 11:33am
Print Post  
I will be getting one in July and this will give me a starting point.
Thanks
Carney
  
Back to top
 
IP Logged
 
Maynard Buff
Newbie
*
Offline



Posts: 9
Location: Virginia
Joined: Mar 1st, 2016
Re: H & R Trapdoor
Reply #4 - Jun 2nd, 2022 at 5:16pm
Print Post  
I also have an H&R Officers Mdl, have found the old 2400 load with cotton (18gr) and a 441 Ohaus bullet is very accurate.  However, I have switched to a Lyman 457191, 293 gr bullet with 12gr Unique as it shoots very accurately and is a milder recoil.  Put a Lee Shaver rear sight on it as the original tang is very finicky to adjust.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2025. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.1841 seconds.