ASSRA Forum › General › Gunsmithing Single Shot Rifles › #4 Remington Rolling Block
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic #4 Remington Rolling Block (Read 724 times)
jfeldman
ASSRA Board Member
*****
Offline



Posts: 1120
Location: Imperial Beach, Ca
Joined: Nov 5th, 2005
#4 Remington Rolling Block
Nov 18th, 2021 at 9:05pm
Print Post  
I'm converting this little boy's rifle from .25 RF to .22 RF.  I've bought and fitted a new extractor but I'm unsure about the relief cut in the extractor where the firing pin strikes - like how deep it should be and how far down it should extend.  Any advice would be most welcome.  Thanks in advance,

Regards,
Joe
« Last Edit: Nov 19th, 2021 at 3:59pm by jfeldman »  
Back to top
 
IP Logged
 
ballardhepburnmich
ASSRA Board Member
*****
Offline



Posts: 598
Location: Scotts,mi.
Joined: May 20th, 2015
Re: #4 Remington Rolling Block
Reply #1 - Nov 19th, 2021 at 2:06am
Print Post  
I would say roughleepy. 030 deep and about. 050 down, that should give plenty of clearance. 
Lee Gibbs
  
Back to top
 
IP Logged
 
jfeldman
ASSRA Board Member
*****
Offline



Posts: 1120
Location: Imperial Beach, Ca
Joined: Nov 5th, 2005
Re: #4 Remington Rolling Block
Reply #2 - Nov 19th, 2021 at 4:00pm
Print Post  
Thank you Lee!

Regards,
Joe
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.0470 seconds.