ASSRA Forum › General › Gunsmithing Single Shot Rifles › Uberti low wall ejector
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Uberti low wall ejector (Read 909 times)
Joe_S
Frequent Elocutionist
*****
Offline



Posts: 1108
Joined: Jun 29th, 2004
Uberti low wall ejector
Nov 1st, 2021 at 8:24pm
Print Post  
Hello everyone!

I have a Uberti Low wall that I am thinking about re-barreling. If I do so, would it be possible/feasible to install an ejector spring? Anyone ever do it?
Thanks!
Joe S
  
Back to top
 
IP Logged
 
calledflyer
Frequent Elocutionist
*****
Offline



Posts: 3970
Joined: Mar 9th, 2015
Re: UbeCrti low wall ejector
Reply #1 - Nov 1st, 2021 at 11:32pm
Print Post  
Why do you want one of them? Never owned a repro, but all the originals I ever owned would pop a case out with enough vigor if I just snapped the lever down with a bit of emphasis. Oh, I forgot my .22 which does have a sprung extractor, but not very strongly.
  
Back to top
 
IP Logged
 
bpcrnut
Junior Member
**
Offline



Posts: 51
Location: SE Mn
Joined: Nov 2nd, 2018
Re: Uberti low wall ejector
Reply #2 - Nov 2nd, 2021 at 9:45am
Print Post  
It probably can be done but I’m not sure it’s worth the effort.  In addition to having to drill a hole through the face of the action and then square it up, you will likely have to modify your extractor.  Then you have to make a relief cut on your forearm for the extractor screw.   

Finally, when all that is done you may not be all that happy with the results.  I have several originals and none of them are all that impressive ejecting the case with complete reliability.
  
Back to top
AIM  
IP Logged
 
rkba2nd
Frequent Elocutionist
*****
Offline



Posts: 2102
Location: earth
Joined: Feb 16th, 2009
Re: Uberti low wall ejector
Reply #3 - Nov 2nd, 2021 at 2:44pm
Print Post  
Ruger No 1 is an exception, ejects with authority, or just barely. Retro fitting may make things somewhat more complicated as has been stated, and never found a need, unless I had a chance to hunt Cape Buffalo, Lion etc.
  
rkba2nd
Back to top
 
IP Logged
 
Joe_S
Frequent Elocutionist
*****
Offline



Posts: 1108
Joined: Jun 29th, 2004
Re: Uberti low wall ejector
Reply #4 - Nov 2nd, 2021 at 4:32pm
Print Post  
I have an original High wall musket with the ejector spring and I like the way it works, however, I am not willing to open a Pandora's box to put one in the Uberti replica. Extraction is not a problem so I guess I wont fix it if it isnt broke.
Thanks for the replies!
Joe S
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.6464 seconds.