ASSRA Forum › General › Gunsmithing Single Shot Rifles › Scope block spacing ID
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Scope block spacing ID (Read 751 times)
westerner
Frequent Elocutionist
*****
Offline


deleted posts and threads
record holder.

Posts: 12348
Location: Why, out West of course
Joined: May 29th, 2006
Scope block spacing ID
Oct 29th, 2021 at 9:15pm
Print Post  
Unertl/lyman base screw spacing. .700 and .820. Don't remember ever encountering those sizes. Anyone?
« Last Edit: Oct 29th, 2021 at 9:21pm by westerner »  
A blind squirrel runs into a tree every once in a while.
Back to top
 
IP Logged
 
Dellet
Frequent Elocutionist
*****
Offline



Posts: 1303
Joined: May 19th, 2017
Re: Scope block spacing ID
Reply #1 - Oct 29th, 2021 at 9:25pm
Print Post  
I believe that is Steven’s. I would have to measure one to be certain, and will do that when I get home, unless someone else can verify.

The bolt holes would tapped 5/40, on a Stevens if that helps.
  
Back to top
 
IP Logged
 
westerner
Frequent Elocutionist
*****
Offline


deleted posts and threads
record holder.

Posts: 12348
Location: Why, out West of course
Joined: May 29th, 2006
Re: Scope block spacing ID
Reply #2 - Oct 29th, 2021 at 9:48pm
Print Post  
I thought the holes looked a little small. Thought it was fuzz. Yep, they won't take a 6X48.
  
A blind squirrel runs into a tree every once in a while.
Back to top
 
IP Logged
 
Dellet
Frequent Elocutionist
*****
Offline



Posts: 1303
Joined: May 19th, 2017
Re: Scope block spacing ID
Reply #3 - Oct 29th, 2021 at 10:06pm
Print Post  
I just looked at Steve Earle’s website. He lists Stevens at .700” and .825”. I’ll still check, but he did a set for me a couple years ago that fit.The original Stevens were a V cut for the mount.


If you have blocks looking for a barrel, I think I have one. Grin
  
Back to top
 
IP Logged
 
westerner
Frequent Elocutionist
*****
Offline


deleted posts and threads
record holder.

Posts: 12348
Location: Why, out West of course
Joined: May 29th, 2006
Re: Scope block spacing ID
Reply #4 - Oct 29th, 2021 at 10:32pm
Print Post  
Thanks Tod.  Nope, have a barrel with no blocks. The block spacing is about 9 3/4. Will just make it for eye relief. I'll check his site.
  
A blind squirrel runs into a tree every once in a while.
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.3726 seconds.