ASSRA Forum - MVA Malcolm Rear Mount Question

ASSRA Forum › General › Gunsmithing Single Shot Rifles › MVA Malcolm Rear Mount Question

(Moderator Group: Moderator)

‹ Previous Topic | Next Topic ›

Pages: 1

MVA Malcolm Rear Mount Question (Read 1038 times)

bpjack Frequent Elocutionist Online Posts: 3779 Location: East Olympia, WA Joined: May 18^th, 2008	MVA Malcolm Rear Mount Question Jul 23^rd, 2021 at 3:28pm	Print Post
	I just picked up a set of MVA schuetzen style mounts and was wondering if I am missing a piece. a 3/4" tube rattles around slightly in the rear mount. Is there supposed to be something to apply tension? Possible related to the 2 screws on top of the mount? Thanks Jack


	IP Logged

Old-Win Frequent Elocutionist Offline Posts: 1825 Location: Minnesota Joined: Nov 24^th, 2005	Re: MVA Malcolm Rear Mount Question Reply #1 - Jul 23^rd, 2021 at 4:23pm	Print Post
	Yes, there are two tiny little nylon detente balls that go between the spring and the scope and applies tension to the scope tube.


	IP Logged

bpjack Frequent Elocutionist Online Posts: 3779 Location: East Olympia, WA Joined: May 18^th, 2008	Re: MVA Malcolm Rear Mount Question Reply #2 - Jul 23^rd, 2021 at 7:08pm	Print Post
	Ok, thanks. I will contact MVA and see if I can get some. Jack


	IP Logged

bpjack Frequent Elocutionist Online Posts: 3779 Location: East Olympia, WA Joined: May 18^th, 2008	Re: MVA Malcolm Rear Mount Question Reply #3 - Jul 26^th, 2021 at 4:17pm	Print Post
	I found a solution. Hobby Lobby #148007 3mm white plastic beads. 1000 for $2.99. Should be a lifetime supply even if they do fall out when you remove the mount. Jack


	IP Logged

Pages: 1

‹ Previous Topic | Next Topic ›

Page completed in 0.4512 seconds.