ASSRA Forum › General › Gunsmithing Single Shot Rifles › BSA Int trigger upgrade
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic BSA Int trigger upgrade (Read 1053 times)
Joe_S
Frequent Elocutionist
*****
Offline



Posts: 1108
Joined: Jun 29th, 2004
BSA Int trigger upgrade
May 1st, 2021 at 2:52am
Print Post  
I have two BSA Int. (Mk1) rifles, one has the upgraded trigger and the other does not. The one with the externally adjustable trigger has a perfectly light and safe trigger, the other has the trigger group that is not upgraded, and I cannot get it adjusted to my satisfaction. If there a gunsmith out there who does trigger upgrades to the Mk I triggers to make them externally adjustable? I can swap the trigger group between the two rifles, but would prefer to upgrade the internally adjustable one. I would also be willing to buy a Mk I trigger with the upgrades.
Thanks!
Joe S
  
Back to top
 
IP Logged
 
PORK AND BEANS
Junior Member
**
Offline



Posts: 70
Location: clovis,ca
Joined: Sep 13th, 2009
Re: BSA Int trigger upgrade
Reply #1 - May 1st, 2021 at 11:58am
Print Post  
I would also be interested in an upgraded trigger for my Mk1.
Rich$
  
Back to top
 
IP Logged
 
pronechamp
Participating Member
*
Offline



Posts: 22
Location: West Bloomfield, MI
Joined: Mar 1st, 2012
Re: BSA Int trigger upgrade
Reply #2 - May 11th, 2021 at 11:24am
Print Post  
The original BSA models, sometimes referred to as MK 1 have internally adjustable triggers, but this work is difficult and the set up was intended to meet the old 3# trigger rule of the day.

Suggest contacting Mark Cheseboro on this issue.  He is the sucessor to the MT guns operation.
  
Back to top
 
IP Logged
 
gnoahhh
Frequent Elocutionist
*****
Offline



Posts: 1063
Location: Gaithersburg, MD
Joined: Mar 31st, 2010
Re: BSA Int trigger upgrade
Reply #3 - May 11th, 2021 at 4:16pm
Print Post  
Seriously, I don't see the need to upgrade the MK I trigger assembly. I have a "MK I" and had no trouble whatsoever in adjusting my pull down to a scant one pound release with zero creep. The trigger assembly/breech block drops right out and armed with two Allen wrenches of the right size it's a job of minutes to do. It can all be done with the assembly out of the gun. Furthermore, after the light pull was achieved it has never slam fired, and I took a second place in smallbore BR competition two weekends ago with it, beaten by one point, at 100 yards.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.5731 seconds.