ASSRA Forum › General › Gunsmithing Single Shot Rifles › 1885 receiver threads
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 [2]  Send TopicPrint
Hot Topic (More than 10 Replies) 1885 receiver threads (Read 4821 times)
Bent_Ramrod
Frequent Elocutionist
*****
Offline



Posts: 1582
Location: Southern Arizona
Joined: Feb 8th, 2006
Re: 1885 receiver threads
Reply #15 - Feb 7th, 2021 at 6:12pm
Print Post  
If the OP has a lathe and no tap, he could reproduce the barrel threads on a piece of mild steel round stock, grind, file or mill  a couple longitudinal relief grooves, deburr and caseharden the thing, and use it to chase the threads.

With a lathe, all things are possible.  Smiley
  
Back to top
 
IP Logged
 
wesg
Senior Forum Member
****
Offline



Posts: 333
Joined: Sep 13th, 2004
Re: 1885 receiver threads
Reply #16 - Feb 11th, 2021 at 6:36pm
Print Post  
I had the option, and desire, of surface grinding the sides. that made it easy to fixture. This thing was about 3/4° out from the face and block mortise, which were about as true to each other as could be expected.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 [2] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.3766 seconds.