ASSRA Forum › General › Rifle Photos › Ruger No.1 Build
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 [2]  Send TopicPrint
Hot Topic (More than 10 Replies) Ruger No.1 Build (Read 3724 times)
singleshotsam
Oldtimer
*****
Offline



Posts: 551
Location: Silver City NM
Joined: Jan 15th, 2009
Re: Ruger No.1 Build
Reply #15 - Aug 24th, 2022 at 8:19am
Print Post  
I have a Ruger #1 with a Shilen 6.5X55 barrel and it is a really fine rifle. I installed a Jard trigger and actually like it better than the 2 Kepplingers that I have It seems to have a more crisp break. The trigger offered by EAB is made by Jard. I ordered 4 directly from Jard and received a discount, that was several years back.
  
Back to top
 
IP Logged
 
ISS
Oldtimer
*****
Offline



Posts: 570
Joined: Feb 24th, 2013
Re: Ruger No.1 Build
Reply #16 - Aug 25th, 2022 at 4:06am
Print Post  
I bought a very nice #1 here in 223 with an 8" twist.  I plan to rechamber it, and am debating whether to go 22-250 or 220 Swift.  I built a 22-284 many years ago, but it was a bit too much fun, and a barrel eater.

JARD trigger, eh?

thanks gentlemen,

Rich
  
Back to top
 
IP Logged
 
rkba2nd
Frequent Elocutionist
*****
Offline



Posts: 1905
Location: earth
Joined: Feb 16th, 2009
Re: Ruger No.1 Build
Reply #17 - Aug 27th, 2022 at 3:27pm
Print Post  
ISS        You might consider a 5.6x50 or 222 mag. both good and inherently accurate rounds, and easier on barrels. If you are looking for a longer range varmint round, your choices would be better, as you could take advantage of the 8 twist and heavier bullets with better long range ballistics, and the capacity to get them there.
  
rkba2nd
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 [2] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.2857 seconds.