ASSRA Forum › General › Gunsmithing Single Shot Rifles › Low Wall rimfire
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Low Wall rimfire (Read 1484 times)
JSH
Newbie
*
Offline



Posts: 1
Joined: Feb 8th, 2016
Low Wall rimfire
Nov 28th, 2017 at 9:19pm
Print Post  
I am asking for a friend
He needs a blue print for a low wall barrel tenon and extractor cuts. 
If there is a link to such info could you guide me to it? 
Thanks
Jeff
  
Back to top
 
IP Logged
 
marlinguy
Frequent Elocutionist
*****
Offline


Ballards may be weaker,
but they sure are neater!

Posts: 16159
Location: Oregon
Joined: Feb 2nd, 2009
Re: Low Wall rimfire
Reply #1 - Nov 29th, 2017 at 10:25am
Print Post  
Extractor cut for a RF Low wall is the entire lower half of the barrel. The RF extractor covers that whole bottom half.

(You need to Login or Register to view media files and links)
  
(You need to Login or Register to view media files and links)
Back to top
 
IP Logged
 
JSB30
Senior Forum Member
****
Offline



Posts: 395
Location: Missouri
Joined: Apr 30th, 2011
Re: Low Wall rimfire
Reply #2 - Nov 29th, 2017 at 4:58pm
Print Post  
If rebarreling a rimfire best way for extractor  is two piece extractor from DZ. Far easier to fit. Original is real pain.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.5623 seconds.