ASSRA Forum › General › Collecting Single Shot Rifles › Remington forend fit
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Remington forend fit (Read 1567 times)
.22-5-40
Oldtimer
*****
Offline



Posts: 802
Joined: Feb 13th, 2010
Remington forend fit
May 3rd, 2016 at 3:55pm
Print Post  
I know Remington set their barrels fairly shallow in forend, but is it common to see a gap between wood & lower corner of vertical barrel flat on an oct. or 1/2 oct?
  
Back to top
 
IP Logged
 
Quarter_Bore
Oldtimer
*****
Offline



Posts: 817
Location:   
Joined: Dec 16th, 2005
Re: Remington forend fit
Reply #1 - May 3rd, 2016 at 7:52pm
Print Post  
I don't know about all Remingtons but on Hepburns the forearm only covers the three bottom barrel flats.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.0654 seconds.