ASSRA Forum › General › Reloading the Single Shot Rifle › 32-40 Remington
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic 32-40 Remington (Read 1510 times)
PeeJay
Newbie
*
Offline



Posts: 3
Location: 80212
Joined: Jul 8th, 2013
32-40 Remington
Feb 26th, 2016 at 9:38am
Print Post  
Can someone out there help me with a light load, around 11 hundred fps for my newly acquired Maynard chambered in 32-40 Remington. I will be using a 150 gr. rnfp gas check bullet. Trim to length measurement would be helpful also. Thanks in advance.
  
Back to top
 
IP Logged
 
beltfed
Frequent Elocutionist
*****
Offline



Posts: 1824
Location: Central Wi
Joined: Dec 20th, 2007
Re: 32-40 Remington
Reply #1 - Feb 26th, 2016 at 9:46am
Print Post  
I am shooting a load of 15.5 gr IMR 4227 under a 200 gr lyman 311299 bullet in my 32-40 Rem Hep 
It is noted that this neat old ctg has almost the same case capacity of a  30-30 WCF. So, you could try "starting load" data for your Maynard.  I expect Unique in a starting load may be just what you are looking for
beltfed/arnie
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.2204 seconds.