ASSRA Forum - Whats the best method to make a extractor cut ?

ASSRA Forum › General › Gunsmithing Single Shot Rifles › Whats the best method to make a extractor cut ?

(Moderator Group: Moderator)

‹ Previous Topic | Next Topic ›

Pages: 1

Whats the best method to make a extractor cut ? (Read 2486 times)

Frankford Full Member Offline Posts: 162 Location: Clint, TX Joined: Dec 20^th, 2012	Whats the best method to make a extractor cut ? Sep 25^th, 2015 at 12:52am	Print Post
	Whats the best method to make a extractor cut in a freshly breached and headspaced Borchardt barrel ? I mean to match the receiver cutouts.


	IP Logged

harry_eales Ex Member	Re: Whats the best method to make a extractor cut ? Reply #1 - Sep 25^th, 2015 at 9:12am	Print Post
	Hello Greg. The word is carefully. lol. Photographs attached. Harry


	IP Logged

Chuckster Frequent Elocutionist Offline Posts: 2240 Location: Colorado Joined: May 15^th, 2008	Re: Whats the best method to make a extractor cut ? Reply #2 - Sep 25^th, 2015 at 12:03pm	Print Post
	Sure looks like a job for a job for a Woodruff cutter, which are available from any machine tool supplier. Chuck


	IP Logged

Frankford Full Member Offline Posts: 162 Location: Clint, TX Joined: Dec 20^th, 2012	Re: Whats the best method to make a extractor cut ? Reply #3 - Sep 25^th, 2015 at 4:35pm	Print Post
	It looks like the 1st cut was parallel to the threads, from the breech face forward. That would give a clean surface for layout marks. Then a Woodruff cutter is used for the Center Line side cut. Anyone happen to have the "Radiuses" ? or Radii


	IP Logged

Pages: 1

‹ Previous Topic | Next Topic ›

Page completed in 1.0717 seconds.