ASSRA Forum › General › Gunsmithing Single Shot Rifles › no. 1 Winchester replacement barrel
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic no. 1 Winchester replacement barrel (Read 2283 times)
tdelewis
Full Member
***
Offline



Posts: 119
Joined: Aug 22nd, 2013
no. 1 Winchester replacement barrel
Sep 18th, 2015 at 9:37am
Print Post  
Is anyone producing a No. 1 Winchester barrel for replacing an original 22 rimfire No. 1, 24 inch?  Green Mountain has No. 2 profile but not a No. 1.  I did a search and nothing comes up.  I won't go to a custom barrel maker as the wait is long and usually expensive.  If I can't find one I will just work with the one I have.  It will take a lot of work to get it looking good as the edges of the flats have much damage but the gun is good.
  
Back to top
 
IP Logged
 
Smoke
Oldtimer
*****
Offline



Posts: 716
Location: San Diego
Joined: Feb 24th, 2013
Re: no. 1 Winchester replacement barrel
Reply #1 - Sep 18th, 2015 at 11:26am
Print Post  
Have you called CPA?  They have blanks in stock from Douglas and perhaps other makers, and will profile them to your specs.

Their prices are reasonable and their timing is usually good.

  
Back to top
 
IP Logged
 
SSShooter
Frequent Elocutionist
*****
Offline



Posts: 2923
Location: Southern NJ
Joined: Aug 1st, 2010
Re: no. 1 Winchester replacement barrel
Reply #2 - Sep 18th, 2015 at 2:15pm
Print Post  
Do much draw/flat filing on a #1 and it will soon be a #0.5.
  
Glenn - 2x CPA 44 1/2 w/22LR (Shilen ratchet-rifled & Bartlein 5R rifled), 38-40RH & 38-55WCF (Bartlein 5R rifled) & 40-65WCF (GrnMtn 'X') barrels
Back to top
GTalk  
IP Logged
 
beltfed
Frequent Elocutionist
*****
Offline



Posts: 1761
Location: Central Wi
Joined: Dec 20th, 2007
Re: no. 1 Winchester replacement barrel
Reply #3 - Sep 19th, 2015 at 12:04pm
Print Post  
Otherwise, consider lining the original barrel if it is not
too "bad" on the exterior
Worked well on my lo wall 22 and on my Stevens tipup.
beltfed/arnie
  
Back to top
 
IP Logged
 
AJ
Full Member
***
Offline



Posts: 151
Joined: Aug 25th, 2011
Re: no. 1 Winchester replacement barrel
Reply #4 - Sep 19th, 2015 at 5:19pm
Print Post  
I'm not positive on this, but I think if you look at Green Mountain Lever Action Barrels/Octagon barrels you will see a blank close to a No.1.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2025. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.0786 seconds.