ASSRA Forum › General › Gunsmithing Single Shot Rifles › Re: Ballard Double Set Trigger....
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Re: Ballard Double Set Trigger.... (Read 2047 times)
Schutzenbob
Frequent Elocutionist
*****
Offline


Rheinisch-Westfälisc
hen Sprengstoff-Fabriken

Posts: 2074
Location: Nightingale, California
Joined: Oct 24th, 2005
Re: Ballard Double Set Trigger....
Jun 4th, 2015 at 12:13am
Print Post  
I believe that #13 and #14 are #5-40 but I'm not sure.
« Last Edit: Jun 4th, 2015 at 1:01am by Schutzenbob »  
Back to top
 
IP Logged
 
marlinguy
Frequent Elocutionist
*****
Offline


Ballards may be weaker,
but they sure are neater!

Posts: 16425
Location: Oregon
Joined: Feb 2nd, 2009
Re: Ballard Double Set Trigger....
Reply #1 - Jun 4th, 2015 at 12:42am
Print Post  
If you're referring to the adjustment screw (#15) then I think it's smaller than the trigger plate screws.
  
(You need to Login or Register to view media files and links)
Back to top
 
IP Logged
 
kensmachine
Oldtimer
*****
Offline



Posts: 574
Joined: Nov 21st, 2012
Re: Ballard Double Set Trigger....
Reply #2 - Jun 4th, 2015 at 1:47am
Print Post  
the two that hold the trigger plate to the breech block are 42 TPI not 40 tpi. I have all  the screws for the trigger assy that would be a #14 front and #13rear mounting screws the #8 front and #4 rear trigger springs screws and the # 15 adjusting screw these are for the small pin triggers Dave I sent you an email Ken
« Last Edit: Jun 4th, 2015 at 1:55am by kensmachine »  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2025. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.0736 seconds.