ASSRA Forum › General › Gunsmithing Single Shot Rifles › Hoch Breech Block
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Hoch Breech Block (Read 2117 times)
Myers
Senior Forum Member
****
Offline



Posts: 382
Joined: Mar 5th, 2013
Hoch Breech Block
Apr 2nd, 2015 at 6:51pm
Print Post  
How do you remove the firing pin assembly from the breech block?
  
Back to top
 
IP Logged
 
jfeldman
ASSRA Board Member
*****
Offline



Posts: 1083
Location: Imperial Beach, Ca
Joined: Nov 5th, 2005
Re: Hoch Breech Block
Reply #1 - Apr 2nd, 2015 at 11:10pm
Print Post  
Remove the dovetailed piece from the rear of the breechblock and withdraw the striker spring.  Remove the sideplate and lift out the striker.  This for the early (USA) kits.  Later ones from Meacham had a plug at the rear of the breechblock.  Hope this helps.

Regards, Joe
  
Back to top
 
IP Logged
 
Myers
Senior Forum Member
****
Offline



Posts: 382
Joined: Mar 5th, 2013
Re: Hoch Breech Block
Reply #2 - Apr 3rd, 2015 at 9:07am
Print Post  
I have the Meacham with the plug. That plug has got me puzzled. How to remove it.
  
Back to top
 
IP Logged
 
Schuetzendave
Frequent Elocutionist
*****
Offline


Retired Ex-Shooter

Posts: 4051
Location: St. Albert, Alberta
Joined: Jan 28th, 2005
Re: Hoch Breech Block
Reply #3 - Apr 3rd, 2015 at 12:06pm
Print Post  
The Meachem Hoch came with a wrench with two pins in it to insert into the plug.

Two finishing nails and a set of needle nose pliers works to unscrew the plug when you do not have the plug wrench.
  
Back to top
 
IP Logged
 
Myers
Senior Forum Member
****
Offline



Posts: 382
Joined: Mar 5th, 2013
Re: Hoch Breech Block
Reply #4 - Apr 3rd, 2015 at 12:09pm
Print Post  
Thanks Dave...you da man eh?
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.5933 seconds.