ASSRA Forum - Hoch Breech Block

ASSRA Forum › General › Gunsmithing Single Shot Rifles › Hoch Breech Block

(Moderator Group: Moderator)

‹ Previous Topic | Next Topic ›

Page Index Toggle

Pages: 1

Normal Topic

Hoch Breech Block (Read 2114 times)

Myers Senior Forum Member Offline Posts: 382 Joined: Mar 5^th, 2013	Hoch Breech Block Apr 2^nd, 2015 at 6:51pm	Print Post
	How do you remove the firing pin assembly from the breech block?


	IP Logged

jfeldman ASSRA Board Member Offline Posts: 1083 Location: Imperial Beach, Ca Joined: Nov 5^th, 2005	Re: Hoch Breech Block Reply #1 - Apr 2^nd, 2015 at 11:10pm	Print Post
	Remove the dovetailed piece from the rear of the breechblock and withdraw the striker spring. Remove the sideplate and lift out the striker. This for the early (USA) kits. Later ones from Meacham had a plug at the rear of the breechblock. Hope this helps. Regards, Joe


	IP Logged

Myers Senior Forum Member Offline Posts: 382 Joined: Mar 5^th, 2013	Re: Hoch Breech Block Reply #2 - Apr 3^rd, 2015 at 9:07am	Print Post
	I have the Meacham with the plug. That plug has got me puzzled. How to remove it.


	IP Logged

Schuetzendave Frequent Elocutionist Offline Retired Ex-Shooter Posts: 4051 Location: St. Albert, Alberta Joined: Jan 28^th, 2005	Re: Hoch Breech Block Reply #3 - Apr 3^rd, 2015 at 12:06pm	Print Post
	The Meachem Hoch came with a wrench with two pins in it to insert into the plug. Two finishing nails and a set of needle nose pliers works to unscrew the plug when you do not have the plug wrench.


	IP Logged

Myers Senior Forum Member Offline Posts: 382 Joined: Mar 5^th, 2013	Re: Hoch Breech Block Reply #4 - Apr 3^rd, 2015 at 12:09pm	Print Post
	Thanks Dave...you da man eh?


	IP Logged

Page Index Toggle

Pages: 1

‹ Previous Topic | Next Topic ›

« Board Index ‹ Board Top

Top

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid XHTML

Valid CSS

Powered by Perl

Source Forge

Page completed in 1.1516 seconds.