ASSRA Forum - Need help from a QuickLoad Guru

ASSRA Forum › General › Reloading the Single Shot Rifle › Need help from a QuickLoad Guru

(Moderator Group: Moderator)

‹ Previous Topic | Next Topic ›

Pages: 1

Need help from a QuickLoad Guru (Read 2121 times)

Bulseyetom Frequent Elocutionist Offline Posts: 1022 Location: Santa Maria, Ca Joined: Oct 31^st, 2010	Need help from a QuickLoad Guru Mar 26^th, 2015 at 11:15am	Print Post
	I have Quickload and use it for lots of my wildcat cartridges but now I have a new task and I am not sure how to do it. I want to create a new wildcat cartridge on the computer to see what velocities I might get at 40,000 psi. Basically I want to see how a 303 Savage case would be necked down to 28 caliber with a .300 long neck and a 30* neck to a minimum taper shoulder at say 0.430. How to I go about creating this beast in Quickload? Thanks. Tom


	Twitter IP Logged

uscra112 Frequent Elocutionist Offline Posts: 4079 Location: Switzerland of Ohio Joined: May 7^th, 2007	Re: Need help from a QuickLoad Guru Reply #1 - Mar 31^st, 2015 at 5:31am	Print Post
	Upper part of the screen are a series of "buttons". Fourth from the left lets you create a new cartridge. Click and fill in the data. You'll have to guess on case capacity until you have a case made and can measure the water capacity. There is, as far as I can see, no factor(s) for shoulder angle and/or ratio of body diameter to neck diameter.

	<div class=
	IP Logged

Bulseyetom Frequent Elocutionist Offline Posts: 1022 Location: Santa Maria, Ca Joined: Oct 31^st, 2010	Re: Need help from a QuickLoad Guru Reply #2 - Mar 31^st, 2015 at 12:56pm	Print Post
	Thank you


	Twitter IP Logged

Pages: 1

‹ Previous Topic | Next Topic ›

Page completed in 1.0107 seconds.