ASSRA Forum › General › Reloading the Single Shot Rifle › Corbin Bullet Swage Press
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Corbin Bullet Swage Press (Read 1473 times)
Grego
Ex Member


Corbin Bullet Swage Press
Dec 11th, 2014 at 11:24pm
Print Post  
Hello,

would very much appreciate hearing from those using the Corbin bullet press.
  - Degree of difficulty with setup
  - Ease (or not) of operation
  - Degree of satisfaction with results
  - Would you choose to use the Corbin again?
  - Would you recommend to a friend

Thanks Gents
  
Back to top
 
IP Logged
 
40_Rod
Frequent Elocutionist
*****
Offline


Extremism in the persuit
of accuracy is not a
vice

Posts: 4285
Location: Knoxville, TN
Joined: Apr 20th, 2004
Re: Corbin Bullet Swage Press
Reply #1 - Dec 12th, 2014 at 8:45am
Print Post  
I have a Corbin stage II press that I have had for years. I played with swageing for a while and then had a set of dies made that conform to my ideal tapered throat. I still use those dies after I cast and lube my bullets to make sure everything is true. 
  The press also comes with an adaptor so that you can use it as a reloading press. It has more strength and rigidity than any other press that I have seen. I use that press for all my case forming work also.

40 Rod
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.4669 seconds.