ASSRA Forum › General › Reloading the Single Shot Rifle › Some Molds are Enjoyable to Cast With ...
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 [2]  Send TopicPrint
Hot Topic (More than 10 Replies) Some Molds are Enjoyable to Cast With ... (Read 7266 times)
rkaires
Frequent Elocutionist
*****
Offline


No Stronger Bond

Posts: 1671
Location: Dingmans Ferry, PA
Joined: Oct 26th, 2012
Re: Some Molds are Enjoyable to Cast With ...
Reply #15 - Apr 26th, 2014 at 2:48pm
Print Post  
Hi John,

The bullet I cast before knocking off one of my Honey-do chores was 386.0gr. The one I cast when I returned was 385.9. I was surprised myself. My aluminum mould would be close to a 1gr difference on a similar bullet. I will try this again on my next casting session to see if the results are similar.
  
ASSRA #11031
NRA Life
Proud Noodlehead

"Peace is that brief, glorious moment in history, when everybody stands
around reloading."~ ~ Thomas Jefferson
Back to top
 
IP Logged
 
JLouis
Frequent Elocutionist
*****
Offline



Posts: 10625
Joined: Apr 8th, 2009
Re: Some Molds are Enjoyable to Cast With ...
Reply #16 - Apr 26th, 2014 at 3:36pm
Print Post  
Thanks Bob interesting results, typicaly the variation would be higher as you noted.

Thanks for responce.
JLouis
  
" It Is Better To Now Have Been A Has Been Than A Never Was Or A Wanna Be "
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 [2] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.5353 seconds.