ASSRA Forum › General › Reloading the Single Shot Rifle › Boomers Bullet Moulds
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 [2]  Send TopicPrint
Hot Topic (More than 10 Replies) Boomers Bullet Moulds (Read 16165 times)
SgtDog0311
Senior Forum Member
****
Offline



Posts: 391
Joined: Mar 19th, 2014
Re: Boomers Bullet Moulds
Reply #15 - Jan 7th, 2018 at 12:36pm
Print Post  
Well I had a little better luck with the 'search function' than normal.   So far found only one negative comment about drop-size not being right on.
  
Best Regards,
John
Back to top
 
IP Logged
 
Schuetzendave
Frequent Elocutionist
*****
Offline


Retired Ex-Shooter

Posts: 4233
Location: St. Albert, Alberta
Joined: Jan 28th, 2005
Re: Boomers Bullet Moulds
Reply #16 - Jan 7th, 2018 at 5:33pm
Print Post  
Leo will be happy to recut any mold that is found not to be what was requested.

If they are not perfect; he will keep at it to provide you what you requested.
  
Back to top
 
IP Logged
 
SgtDog0311
Senior Forum Member
****
Offline



Posts: 391
Joined: Mar 19th, 2014
Re: Boomers Bullet Moulds
Reply #17 - Jan 7th, 2018 at 6:03pm
Print Post  
Thanks for the input Dave.  Been wanting to try him out for the last couple molds so here I am again at the same decision point.
  
Best Regards,
John
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 [2] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.3317 seconds.