ASSRA Forum › General › Gunsmithing Single Shot Rifles › Barrel shank and threads
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 2 [3]  Send TopicPrint
Very Hot Topic (More than 25 Replies) Barrel shank and threads (Read 12974 times)
colo native
Oldtimer
*****
Offline



Posts: 760
Location: Barren Ridge, Va
Joined: Dec 27th, 2007
Re: Barrel shank and threads
Reply #30 - Oct 26th, 2013 at 8:55pm
Print Post  
I don't have a dog on this,   but if it were mine I would find a good machinest, cut it down an inch n 1/2 or what ever it took, re cut the threads to 80 % min, not what most do..  measuring the thread pitch using the 3 wire method...any lathe operator should kno how to do this to insure proper fit...  the tool bit should have .015 radii to prevent a stress riser...  nuff said..
  
Back to top
 
IP Logged
 
westerner
Frequent Elocutionist
*****
Offline


deleted posts and threads
record holder.

Posts: 12333
Location: Why, out West of course
Joined: May 29th, 2006
Re: Barrel shank and threads
Reply #31 - Oct 28th, 2013 at 12:52am
Print Post  
colo native wrote on Oct 26th, 2013 at 8:55pm:
I don't have a dog on this,   but if it were mine I would find a good machinest, cut it down an inch n 1/2 or what ever it took, re cut the threads to 80 % min, not what most do..  measuring the thread pitch using the 3 wire method...any lathe operator should kno how to do this to insure proper fit...  the tool bit should have .015 radii to prevent a stress riser...  nuff said..


You forgot honest. A good machinist that is "honest". Or........ sober??   Huh

    Joe. 
  
A blind squirrel runs into a tree every once in a while.
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 2 [3] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.6061 seconds.