ASSRA Forum › General › Gunsmithing Single Shot Rifles › Sticking 25/21 cases
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Sticking 25/21 cases (Read 1071 times)
norb68
Participating Member
*
Offline



Posts: 29
Location: Beloit, WI
Joined: Apr 27th, 2011
Sticking 25/21 cases
Sep 24th, 2013 at 4:02pm
Print Post  
I have a 25/21 Stevens 44 1/2, it was originally a .22 cal. but I got another barrel in 25/21and breach block so I can change it back a forth. The 25/21 cases don't seem to wanted to extract after they are shot. Is this a common problem with this caliber?  Any help would be greatly appreciated. norb68
  
Back to top
 
IP Logged
 
frnkeore
Frequent Elocutionist
*****
Offline



Posts: 7650
Location: Central Point, OR 97502
Joined: Jun 16th, 2010
Re: Sticking 25/21 cases
Reply #1 - Sep 24th, 2013 at 4:48pm
Print Post  
Mark one case with a felt pen, fire it. reload and fire 2 more times. If you see a shiny ring develope, the chamber has a buldge in it. 

If it just has straight lines that develope, then it just has a straight chamber w/o any taper. In that case, you can polish the rear half of the chamber and it will extract better.

Frank
  
ASSRA Member #696, ISSA Member #339
Back to top
YIMAIM  
IP Logged
 
norb68
Participating Member
*
Offline



Posts: 29
Location: Beloit, WI
Joined: Apr 27th, 2011
Re: Sticking 25/21 cases
Reply #2 - Sep 24th, 2013 at 5:40pm
Print Post  
Ok Frank thanks I will give that a try. I think it might just be a straight chamber but we will see. norb68
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.4725 seconds.