ASSRA Forum › General › Gunsmithing Single Shot Rifles › winder musket barrel removal procedure
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic winder musket barrel removal procedure (Read 1095 times)
Wild Jeff
Participating Member
*
Offline



Posts: 21
Location: New jersey
Joined: Mar 21st, 2011
winder musket barrel removal procedure
Sep 3rd, 2013 at 3:15pm
Print Post  
Does anybody  know if the ejector spring screw on the front end of the receiver block has to be removed first, or at all, in order to remove the barrel on a Winder coil type mainspring action???
  
Back to top
 
IP Logged
 
Bent_Ramrod
Frequent Elocutionist
*****
Offline



Posts: 1582
Location: Southern Arizona
Joined: Feb 8th, 2006
Re: winder musket barrel removal procedure
Reply #1 - Sep 4th, 2013 at 3:31pm
Print Post  
I take everything off a receiver before removing the barrel, just on general principle.  I put a piece of aluminum in the breech block mortise before I put my action wrench on it.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.7976 seconds.