ASSRA Forum › General › Gunsmithing Single Shot Rifles › .22 / winder extractor
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic .22 / winder extractor (Read 1703 times)
desert-dude
Senior Forum Member
****
Offline



Posts: 439
Location: Selah
Joined: Jul 23rd, 2013
.22 / winder extractor
Aug 21st, 2013 at 10:15pm
Print Post  
Hi all, 
Does anyone have a dimensioned drawing of an extractor for a .22 Winder than has the bump on the front for the ejector spring. 
.jpeg, .dwg, .dxf would be really good. Anything I can make into an
drawing for CAD. 

Many thanks in advance.
  
Back to top
 
IP Logged
 
SSShooter
Frequent Elocutionist
*****
Offline



Posts: 2942
Location: Southern NJ
Joined: Aug 1st, 2010
Re: .22 / winder extractor
Reply #1 - Aug 22nd, 2013 at 7:39am
Print Post  
You can order a set of dimensioned 1885 drawings from the ASSRA archives for $10. Someone else will need to tell you if they include the High Wall rimfire extractor. Been thinking my local multi-axis guy who specializes in 'net near-shape' parts could make a run in the proper steel.
  
Glenn - Stevens 044 1/2, Bartlein SS 5R barrel in 22LR
Back to top
GTalk  
IP Logged
 
desert-dude
Senior Forum Member
****
Offline



Posts: 439
Location: Selah
Joined: Jul 23rd, 2013
Re: .22 / winder extractor
Reply #2 - Aug 22nd, 2013 at 9:58am
Print Post  
I have a set of those drawings. The extractor is the classic one for big bore cartridges.   Some place is my piling system is a drawing from John C for the rimfire extractor but I spent all yesterday morning shuffling thru it and didn't find the right piece of paper.  Some days are like that.
  
Back to top
 
IP Logged
 
Bibbyman
Ex Member


Re: .22 / winder extractor
Reply #3 - Aug 24th, 2013 at 9:22am
Print Post  
Desert-dude and I have been exchanging notes on LW 22 rimfire extractors.   He has sent me a photo of the drawing he has and I started to add dimensions from the original extractor from my early flat spring low wall. But the extractor I have does not nearly match the one in the drawing. The profile is significantly different. 

How many versions of the 1885 22 extractors are there?   Are they different from flat spring to coil spring?  From high to low wall?  Years of manufacturer? 

Anyone have a collection of factory 1885 22 rf extractors that can post pictures of same?

Here is a picture of the original extractor on right and the casting I got from John Taylor. The casting was very close to the original. In most places I only had to file off the outer casting layer.
« Last Edit: Aug 24th, 2013 at 9:29am by »  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.0847 seconds.