ASSRA Forum › General › Gunsmithing Single Shot Rifles › Need help identifying 30-40 Krag barrel
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Need help identifying 30-40 Krag barrel (Read 1394 times)
vol717
Full Member
***
Offline



Posts: 109
Location: Tennessee
Joined: Feb 17th, 2007
Need help identifying 30-40 Krag barrel
Aug 11th, 2013 at 9:59am
Print Post  
I just bought a new, old stock round, tapered barrel chambered in .30-40 Krag. It is threaded 1" 14 TPI with an extractor cut on the left and a big dovetail on the bottom of the barrel about six inches ahead of the breech end.  I was anticipating putting it on a highwall action, but that thread is 1" 16 TPI and the dovetail is too far forward for the Highwall mainspring.  Any ideas what this barrel was intended for ?
  
Back to top
 
IP Logged
 
frnkeore
Frequent Elocutionist
*****
Offline



Posts: 7659
Location: Central Point, OR 97502
Joined: Jun 16th, 2010
Re: Need help identifying 30-40 Krag barrel
Reply #1 - Aug 11th, 2013 at 2:24pm
Print Post  
I considered that barrel myself but, it was to light on the breech end for me. 

It may be for a Hoch, their threads are 1x14. What direction does the cut for the extractor go? Up on the left side tangent to the chamber or into the chamber from the left, at a right angle.

Also, how long are the threads?

BTW, The Winchester HW large threads are about 15/16 dia.

Frank
« Last Edit: Aug 11th, 2013 at 7:54pm by frnkeore »  
ASSRA Member #696, ISSA Member #339
Back to top
YIMAIM  
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.4028 seconds.