ASSRA Forum › General › Collecting Single Shot Rifles › Bullet mold maker ID
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Bullet mold maker ID (Read 3116 times)
winston smith
Ex Member


Bullet mold maker ID
Mar 16th, 2012 at 2:49am
Print Post  
I recently purchased a integral block mold, no guide pins, unvented faces. The mold and handles are unmarked. The sprue plate is stamped 38  255 using individual number stamps, then below using a single stamp is SD&G. The cavity is for a std. 38/55 plain base bullet. The SD&G marking seems familiar but I can't recall the manufacturer.  Maybe someone would know who made this mold?
« Last Edit: Mar 16th, 2012 at 11:53am by »  
Back to top
 
IP Logged
 
J.Francis
Full Member
***
Offline



Posts: 156
Location: Pownal, Vermont
Joined: Nov 20th, 2011
Re: Bullet mold maker ID
Reply #1 - Mar 16th, 2012 at 5:47pm
Print Post  
Your mold was probably marketed by Shoverly, Daly and Gales, a hardware chain that sold a lot of affordable rifles, shotguns and accessories.
  
Back to top
 
IP Logged
 
DWT1885
Senior Forum Member
****
Offline



Posts: 402
Location: New Jersey
Joined: Nov 25th, 2010
Re: Bullet mold maker ID
Reply #2 - Mar 18th, 2012 at 11:20am
Print Post  
Plus I am pretty sure that Bridgeport Gun Implement Co. made the mold itself. Dale.
  
35th Security Police Squadron, Phan Rang AB, RVN, May 70-71.
All gave some, some gave all.
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.9118 seconds.