ASSRA Forum › General › Gunsmithing Single Shot Rifles › beeswax, turpentine and linseed oil stock finish
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic beeswax, turpentine and linseed oil stock finish (Read 3887 times)
Joe_S
Frequent Elocutionist
*****
Offline



Posts: 1108
Joined: Jun 29th, 2004
beeswax, turpentine and linseed oil stock finish
Oct 20th, 2010 at 3:15pm
Print Post  
 
I have a trapdoor that has had the wood cut down but its in beatiful shape otherwise, with very nice color. There doesnt appear to be much finish on it, and I woudl normally put a few coats of Tru-oil on it. However, I bought some beeswax, turpentine and linseed oil finish and I am thinking about using it on this stock. Has anyone had any experience with it? I basically want to give it some protection against moisture. Thanks, Joe S
  
Back to top
 
IP Logged
 
frnkeore
Frequent Elocutionist
*****
Offline



Posts: 7659
Location: Central Point, OR 97502
Joined: Jun 16th, 2010
Re: beeswax, turpentine and linseed oil stock finish
Reply #1 - Oct 20th, 2010 at 4:27pm
Print Post  
A finish that I use that was tested by submerging the wood under water for a week is 50/50 mix of Spar varnish and Linseed oil. I apply 3 coats.

Frank
  
ASSRA Member #696, ISSA Member #339
Back to top
YIMAIM  
IP Logged
 
jimmy
Senior Forum Member
****
Offline


Now available in Oklahoma.

Posts: 467
Location: Skiatook
Joined: May 12th, 2009
Re: beeswax, turpentine and linseed oil stock finish
Reply #2 - Oct 21st, 2010 at 1:26pm
Print Post  
My trapdoor has a weak finish. Wood is in good shape. What should I use if anything to improve the looks and durability while keeping it original? Do not want to sand or refinish. Maybe some oil?

  
Back to top
 
IP Logged
 
MAD MIKE
Oldtimer
*****
Offline



Posts: 655
Location: So Cal
Joined: Oct 31st, 2006
Re: beeswax, turpentine and linseed oil stock finish
Reply #3 - Oct 21st, 2010 at 7:23pm
Print Post  
   Frank, That's about what Tru-Oil is.                                               Jimmy, Just rub in some hardware store Boiled Linseed Oil, 1 or 2 coats should do it.                 ...MIKE...
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.8928 seconds.