ASSRA Forum › General › Gunsmithing Single Shot Rifles › Lyman Wolverine Scope rings
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Lyman Wolverine Scope rings (Read 2694 times)
Gigg
Participating Member
*
Offline



Posts: 39
Location: Fair Oaks, CA
Joined: Feb 9th, 2007
Lyman Wolverine Scope rings
Oct 15th, 2010 at 1:40am
Print Post  
I picked up an old Lyman Wolverine scope on an older SS rifle. rifle.  It was in a set of 1" modern Burris rings and it was clear it didn't fit properly.  The previous owner had shimmed it with tape and simply clamped the rings down.  I measured the scope diameter and it is slightly over 1" more like 1.02".  What did they use for rings on that model?  
I noticed the original rings clamped at 12:00 on each ring with a single sccrew rather than two screws on each side of the rings, top to bottom.
The scope is clear, adjusts well, and is about ten power, but is currently a paper weight until I can figure out a ring solution.
Gigg.  
  
Back to top
 
IP Logged
 
38_Cal
Frequent Elocutionist
*****
Offline



Posts: 2255
Location: Montezuma, Iowa
Joined: Apr 27th, 2005
Re: Lyman Wolverine Scope rings
Reply #1 - Oct 15th, 2010 at 8:52am
Print Post  
You need rings for a 26mm scope.  If you can't find a set, Brownells still makes the adapters that I designed for them, so that you can use a 30mm ring set:  084-000-094.

David
  
David Kaiser
Montezuma, IA
Back to top
 
IP Logged
 
Gigg
Participating Member
*
Offline



Posts: 39
Location: Fair Oaks, CA
Joined: Feb 9th, 2007
Re: Lyman Wolverine Scope rings
Reply #2 - Oct 18th, 2010 at 2:01pm
Print Post  
David
Thank you for the information.  I have ordered the rings and shims to fixt the problem.   
Gigg
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.9490 seconds.