ASSRA Forum › General › Gunsmithing Single Shot Rifles › cutting a slot in a screw head
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 [2]  Send TopicPrint
Hot Topic (More than 10 Replies) cutting a slot in a screw head (Read 14256 times)
Chuckster
Frequent Elocutionist
*****
Offline



Posts: 2312
Location: Colorado
Joined: May 15th, 2008
Re: cutting a slot in a screw head
Reply #15 - Sep 13th, 2010 at 10:40pm
Print Post  
John,
Tried your modified Woodruff cutter. Works very well, better than a slitting saw which usually cut on only a few teeth. Thanks for the post.  Now, if I could just get the slots to line up North and South.
Chuck
  
Back to top
 
IP Logged
 
JakeFlyFish
Ex Member


Re: cutting a slot in a screw head
Reply #16 - Sep 15th, 2010 at 5:09pm
Print Post  
I took a hack saw, ground the edges of the blade over a 4 or 5 inch area and you can cut the skinniest slots you can imagine with that set up and you have the ultimate control over it as well. And it's cheap. Simple grind the sides of the blade to a thin measurement and slot away. Jake
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 [2] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.8001 seconds.