ASSRA Forum › General › Gunsmithing Single Shot Rifles › 32-40 project
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic 32-40 project (Read 1873 times)
buggybuilder
Junior Member
**
Offline



Posts: 94
Location: cornfields of wisconsin
Joined: Jan 7th, 2007
32-40 project
Jun 2nd, 2010 at 11:09pm
Print Post  
I am in the process of building a 32-40 on a Ruger #1 action.
What rate of twist would be the best for a heavy bullet?
What is the best gr. bullet for this barrel---using it for informal target shooting at 200 yds?   
What kind of mould would be recommended?
Does Hoch make a nose-pour mould for the 32-40?
And the last question for this round of questions is.........is brass available and what is the best headstamp to purchase?
Thanks

buggybuider
  
Back to top
YIM  
IP Logged
 
40_Rod
Frequent Elocutionist
*****
Offline


Extremism in the persuit
of accuracy is not a
vice

Posts: 4285
Location: Knoxville, TN
Joined: Apr 20th, 2004
Re: 32-40 project
Reply #1 - Jun 3rd, 2010 at 8:08am
Print Post  
Buggybuilder
As to twist Original was 1:16" most who use a uniform twist use a 1:14"  Ron Smith recommends a final twist of 1:11 1/2" on his gain twist barrels.  For informal target work I would recommend 1:14" from Douglas. Paul Shuttleworth usually has Hoch style moulds the proper size in stock. I believe that there are still a couple of bags of Winchester 32-40 brass on our for sale board.

40 Rod
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.7746 seconds.