ASSRA Forum › General › Gunsmithing Single Shot Rifles › Which Rolling Block for 22 RF
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 [2]  Send TopicPrint
Hot Topic (More than 10 Replies) Which Rolling Block for 22 RF (Read 10667 times)
ssdave
Frequent Elocutionist
*****
Offline



Posts: 2138
Location: Eastern Oregon
Joined: Apr 16th, 2004
Re: Which Rolling Block for 22 RF
Reply #15 - May 20th, 2010 at 11:47pm
Print Post  
I put the breechblock in First Class mail Monday, you should have it tomorrow with any luck.  Sounds like a fun project!

dave
  
Back to top
 
IP Logged
 
John Taylor
Frequent Elocutionist
*****
Online



Posts: 1851
Location: Lewiston, ID
Joined: Oct 23rd, 2006
Re: Which Rolling Block for 22 RF
Reply #16 - May 21st, 2010 at 10:20pm
Print Post  
The breach block was in the box when I got home today. What do I owe you for it? The package was ripped open and I found the sheet showing the Model K action. Where do I get more info on it?
  
John Taylor   Machinist/gunsmith
Back to top
WWW  
IP Logged
 
ssdave
Frequent Elocutionist
*****
Offline



Posts: 2138
Location: Eastern Oregon
Joined: Apr 16th, 2004
Re: Which Rolling Block for 22 RF
Reply #17 - May 21st, 2010 at 11:47pm
Print Post  
Hi, John,

Not sure if I understand the message right, did the breechblock escape from the package?  If so, I'll send another similar one.  I maybe should have packaged it in a box instead of a padded mailer.  You don't owe me anything for it, it's for your use.

The model K diagram was something I forgot to send you a couple of weeks ago. It has the extractor fitting dimensions, might save a bit of time on setup.  Hopefully you received a box with an action, k hornet reamer and a barrel from me.  I've been meaning to take the time and email something about what I'd like done.  I'll try to take the time in the next few days.

dave
  
Back to top
 
IP Logged
 
John Taylor
Frequent Elocutionist
*****
Online



Posts: 1851
Location: Lewiston, ID
Joined: Oct 23rd, 2006
Re: Which Rolling Block for 22 RF
Reply #18 - May 23rd, 2010 at 12:23pm
Print Post  
The block and diagram were both there. With the package being torn I was not sure if there was more to the diagram.
  
John Taylor   Machinist/gunsmith
Back to top
WWW  
IP Logged
 
Page Index Toggle Pages: 1 [2] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.5347 seconds.