ASSRA Forum › General › Gunsmithing Single Shot Rifles › 1885 win (japan) trigger job
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic 1885 win (japan) trigger job (Read 2198 times)
plumloco
Full Member
***
Offline



Posts: 141
Location: Manassas ,VA
Joined: May 20th, 2004
1885 win (japan) trigger job
May 2nd, 2010 at 10:51am
Print Post  
Just purchased a 1885 high wall 45-90 . need a trigger job! It's @ 3.5 lbs now would like a better trigger or a single set trigger. Is there anyone know of a smith?  thanks Plumloco
  
Back to top
 
IP Logged
 
JakeFlyFish
Ex Member


Re: 1885 win (japan) trigger job
Reply #1 - May 2nd, 2010 at 9:13pm
Print Post  
I've done all my 1885's I shoot, but they are original 1885's. If yours has the same mechanics, it's an easy fix. Jake
  
Back to top
 
IP Logged
 
plumloco
Full Member
***
Offline



Posts: 141
Location: Manassas ,VA
Joined: May 20th, 2004
Re: 1885 win (japan) trigger job
Reply #2 - May 3rd, 2010 at 6:51am
Print Post  
Thanks for the reply Jake. It's not like an original. It has no lower tang. It has an adjustable trigger from 3.5 to 5 lbs. Wanted to know if anyone had one done and by whom?  Plumloco
  
Back to top
 
IP Logged
 
plumloco
Full Member
***
Offline



Posts: 141
Location: Manassas ,VA
Joined: May 20th, 2004
Re: 1885 win (japan) trigger job
Reply #3 - May 6th, 2010 at 12:52pm
Print Post  
After a few phone calls. I found out Lee Shaver does a trigger job. They say they can get it down to about a 1-1/2lbs. I will have to wait until he gets back. I think I can live with that! Plumloco
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.3283 seconds.