ASSRA Forum › General › Gunsmithing Single Shot Rifles › Remington #4 rebuild
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Remington #4 rebuild (Read 2286 times)
Dan Stone
Ex Member


Remington #4 rebuild
Mar 11th, 2006 at 9:43pm
Print Post  
Folks,
   I need some help on a Remiongton #4 project rifle I'm working on. The rifle started out as a 32 RF. I relined the barrel to .22 LR and now need some advise on modifing the firing pin. It looks as if I will have to braze a filler in the breach block and redrill the firing pin hoie. Do any of you have a suggestion as to how to get the correct angle on the new firing pin hole? Thanks
Dan Stone
  
Back to top
 
IP Logged
 
38_Cal
Frequent Elocutionist
*****
Offline



Posts: 2248
Location: Montezuma, Iowa
Joined: Apr 27th, 2005
Re: Remington #4 rebuild
Reply #1 - Mar 11th, 2006 at 10:14pm
Print Post  
Get a copy of DeHaas' book, "Mr. Single Shot's Gunsmithing Idea Book" from Brownells or one of the other sources.  This is one of the subjects covered, though I don't recall if it's in the chapter on Rolling Blocks or not.

David
Montezuma, IA
  
David Kaiser
Montezuma, IA
Back to top
 
IP Logged
 
Dan Stone
Ex Member


Re: Remington #4 rebuild
Reply #2 - Mar 12th, 2006 at 6:50am
Print Post  
Thanks 38_Cal,
  I will order the book, I appreciate your help.
Dan
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2025. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.6307 seconds.