ASSRA Forum - Barrel leingth ASSRA rules

ASSRA Forum › General › General Discussion › Barrel leingth ASSRA rules

(Moderator Group: Moderator)

‹ Previous Topic | Next Topic ›

Pages: 1

Barrel leingth ASSRA rules (Read 2649 times)

boats Frequent Elocutionist Offline Posts: 7551 Location: Virginia Joined: Apr 23^rd, 2004	Barrel leingth ASSRA rules Dec 30^th, 2005 at 8:53am	Print Post
	What do you think a Schuezenmaster would say about a bolt on barrel extention to make a 18 inch .22 lr barrel long enough to pass the rule. Esentaly a bloop tube like the free rifle shooters use to add weight. ? Boats


	IP Logged

Asst Ex Member	Re: Barrel leingth ASSRA rules Reply #1 - Dec 30^th, 2005 at 11:28am	Print Post
	Re: TC Encore Schutzen « Reply #7 on: Dec 25th, 2005, 7:28am » Quote Modify Section 1.16 Barrels Barrels may be of any length in excess of 21.5" and any weight, but for bench rifles the barrela shall be about 2" in dia or less. The barrel need NOT be rifled for the entire length but must fully encircle the bullet as it passes through the un-rifled section.


	IP Logged

mes Senior Forum Member Offline Posts: 492 Location: Van Dyne, Wisconsin Joined: Apr 17^th, 2004	Re: Barrel leingth ASSRA rules Reply #2 - Dec 30^th, 2005 at 2:13pm	Print Post
	I think you could roll up a target, tape it on and use that as a barrel extension to be legal. Muzzel blast might rag it up a bit. mes

	Martin Stenback
	IP Logged

boats Frequent Elocutionist Offline Posts: 7551 Location: Virginia Joined: Apr 23^rd, 2004	Re: Barrel leingth ASSRA rules Reply #3 - Dec 30^th, 2005 at 3:55pm	Print Post
	Fully encircle, that's pretty easy to do and a whole lot cheaper than a new barrel. Thanks guys Boats


	IP Logged

Pages: 1

‹ Previous Topic | Next Topic ›

Page completed in 1.1855 seconds.