Very heavy Cody Ballard, .38-50 Rem-Hep with false muzzle and bullet starter. Also included, additional .38-55 barrel with forestock, extra extractor cut for this barrel, barrel sled made by Skip Epp. .38-50 is a Krieger barrel, 1:15 twist with rifled false muzzle by David Mos and Neal Rice when they worked for Ballard Rifle Co. .38-55 is 1:15 twist.
This is the rifle I used for some of the shooting tests in my book: The Golden Age of the American Schuetzenfest. Over the years it has proved to be quite accurate with a number of 1moa (and near 1moa) 10 shot groups shot at 200 yards. Loads were straight black, duplex and BP subs. I've found the rifle shoots equally well muzzle loaded or breech seated. The main difference when muzzle loading, you can shoot dirty with suitable conditions.
Complete 2 barrel set (scope not included) with two Steve Brooks bullet molds for muzzle loading and breech seating, 120 (approx) .38-50 cases formed from RP .30-40 brass plus additional 30 (or so) WW cases also formed from .30-40.
$4,500
I have no way to ship this outfit so a sale has to be face-to-face. I'll travel a reasonable distance to deliver.

Simply put, it's a system whereby one loads a primed and charged case into the chamber, and then loads the bullet down from the muzzle to just shy of the case mouth (or more safely vise-versa), cock the hammer and shoot. Repeat by using the same case and a fresh bullet.

It was/is a means of presenting the bullet straight and squarely into the rifling - and pre-engraving the rifling onto the bullet. Avoidance of the shenanigans a bullet goes through when emerging from a fixed ammo cartridge and into the rifling is an advantage when seeking utmost accuracy. There are more advantages to be had also such as dragging the slight burrs imparted by the rifling lands forward onto the bullet's nose and not having them appear on the all-important base of the bullet (important in that the base is the steering end of the bullet), and also the act of pushing the bullet down from the muzzle scrapes black powder fouling ahead of it thus allowing the act of "shooting dirty" that Randy alluded to (a major consideration when using black powder, not having to clean from the breech after each shot for best accuracy). 

Most of us have found that simply breech seating equals the accuracy of muzzle-breech loading, with the possible/probable exception of when shooting with black powder, but that can be debated and I've often wondered myself. All in all I believe that utmost accuracy from a single shot can best be achieved via muzzle-breech loading but simple breech seating is equal to it most often (and is relatively easier to do). If I weren't in general downsizing mode I would be plotting how to acquire this delectable setup of Mr. Wright's!!

Golly that was a mouthful. Sorry. Did I miss anything?

Very interesting, thanks a bunch for filling me in! 

Logan