ASSRA Forum › General › Single Shot Rifles › Sharing a bit more about my No 2 Ballard
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 [2]  Send TopicPrint
Hot Topic (More than 10 Replies) Sharing a bit more about my No 2 Ballard (Read 288 times)
desertmoon
Junior Member
**
Offline



Posts: 92
Location: Arizona
Joined: Jul 8th, 2019
Re: Sharing a bit more about my No 2 Ballard
Reply #15 - Today at 5:21pm
Print Post  
By the way!  Here is something a lot of folks won't get to see unless they own a Ballard.  What looks like 150 years of goo is actually just the raw casing finish of non critical surfaces in the receiver.

Guys, I am assuming these are likely a malleable iron receiver and not steel or else they are a very early and mild steel suitable for good casting performance.  ( ??? )





  
Back to top
 
IP Logged
 
desertmoon
Junior Member
**
Offline



Posts: 92
Location: Arizona
Joined: Jul 8th, 2019
Re: Sharing a bit more about my No 2 Ballard
Reply #16 - Today at 5:21pm
Print Post  
Another view
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 [2] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.6378 seconds.