ASSRA Forum - The logistics of reloading for my Ballard No 2

ASSRA Forum › General › Reloading the Single Shot Rifle › The logistics of reloading for my Ballard No 2

(Moderator Group: Moderator)

‹ Previous Topic | Next Topic ›

Pages: 1 [2]

The logistics of reloading for my Ballard No 2 (Read 765 times)

RJ-35-40 Senior Forum Member Offline Posts: 382 Location: Saint Augustine Joined: Dec 7^th, 2016	Re: The logistics of reloading for my Ballard No 2 Reply #15 - yesterday at 1:41pm	Print Post
	Please post where you get your dies.. THX desertmoon wrote on Sep 25^th, 2026 at 6:39pm: JHand wrote on Sep 20^th, 2026 at 12:09am: Just another thought on casting with your shot... if you cast for more than schutzen, it works well, like wheel weights or linotype. I use shot to cast up 9mm, 45, 44 & 357 mag, and rifle rounds like 348 with with good results, i even powder coat it and it shoots clean. But with low pressure loads like we use in schutzen and BPCR, it is too hard. So depending on if you do other shooting, it may come in handy. Thank you for the comment. I was thinking of using it as an alloying agent for pure lead. Maybe add 15 percent, then 10 percent, etc until I find a good hardness level. I should probably invest in a Brinelle tester.


	IP Logged

Pages: 1 [2]

‹ Previous Topic | Next Topic ›

Page completed in 1.4830 seconds.