ASSRA Forum › General › General Discussion › Martini Cadets
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Martini Cadets (Read 94 times)
JSB30
Senior Forum Member
****
Offline



Posts: 409
Location: Missouri
Joined: Apr 30th, 2011
Martini Cadets
Yesterday at 10:42am
Print Post  
I got to thinking about my little Martini Cadets last night. Pullet them out of the gun safe this morning  and shot 4 and 6 inch plates at 50 yds. Open sights and my 75 year old eyes don't work together any more. Sure fun to shoot though. 120 grain heeled bullet coated in Alox.
  
Back to top
 
IP Logged
 
waterman
Frequent Elocutionist
*****
Offline



Posts: 3013
Location: Behind the Redwood Curtain
Joined: Jun 9th, 2004
Re: Martini Cadets
Reply #1 - yesterday at 11:17am
Print Post  
My eyes are 11 years older than yours and don't work any better.   

I've used JB weld to stick scope blocks on old rifles, my Winders so far.  Check the alignment, clamp down each block and let it sit for a day before you use it.   

It is supposed to come off and clean up OK, but I haven't tried that.  My eyesight ain't getting better.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.1437 seconds.