ASSRA Forum - heavy trigger pull on 044 1/2

ASSRA Forum › General › General Discussion › heavy trigger pull on 044 1/2

(Moderator Group: Moderator)

‹ Previous Topic | Next Topic ›

Pages: 1

heavy trigger pull on 044 1/2 (Read 190 times)

wildthing Junior Member Offline Posts: 85 Location: Oneida,wi Joined: Jul 7^th, 2010	heavy trigger pull on 044 1/2 Jun 22^nd, 2026 at 7:17pm	Print Post
	The trigger pull on my 0441/2 is well over 5 pounds, what is the best way to reduce the trigger pull on my little rifle? Will thinning the hammer spring lighten the pull? Who makes new hammer springs , I don't want to start messing with mine if I cannot replace it.Any help will be appreciated.


	IP Logged

Dellet Frequent Elocutionist Offline Posts: 1309 Joined: May 19^th, 2017	Re: heavy trigger pull on 044 1/2 Reply #1 - yesterday at 8:33am	Print Post
	A good cleaning, light polishing of the hammer and lube helps. The main spring is the same as the 44 1/2 and generally in stock at CPA. Almost right where the lever contacts the lower tang is a screw that will adjust the spring tension.


	IP Logged

wildthing Junior Member Offline Posts: 85 Location: Oneida,wi Joined: Jul 7^th, 2010	Re: heavy trigger pull on 044 1/2 Reply #2 - yesterday at 2:22pm	Print Post
	Thankyou Dellet. I learn something new every time I get on this fourm.


	IP Logged

Sure shot Frequent Elocutionist Offline Posts: 1173 Location: East central Iowa Joined: Jun 22^nd, 2020	Re: heavy trigger pull on 044 1/2 Reply #3 - yesterday at 4:39pm	Print Post
	The sear/trigger spring for the 044 1/2 uses the same spring as the favorites, 44,and 44 1/2's,as long as it's a standard single trigger. Perhaps someone replaced the sear spring in your rifle with a heavier one.


	IP Logged

Pages: 1

‹ Previous Topic | Next Topic ›

Page completed in 0.9686 seconds.