ASSRA Forum › General › General Discussion › stevens 44 1/2 extra scew
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic stevens 44 1/2 extra scew (Read 224 times)
Win1906
Participating Member
*
Offline



Posts: 24
Location: altona,ny
Joined: Mar 28th, 2026
stevens 44 1/2 extra scew
Jun 15th, 2026 at 8:38am
Print Post  
i have noticed that some 44 1/2 have a extra screw up by the block.im sure one of my books explains it but thought id ask.was it for a ejector type extractor and was it only on 22.
  
Back to top
 
IP Logged
 
Sure shot
Frequent Elocutionist
*****
Offline



Posts: 1169
Location: East central Iowa
Joined: Jun 22nd, 2020
Re: stevens 44 1/2 extra scew
Reply #1 - Jun 15th, 2026 at 10:49am
Print Post  
Yes, it is for the kicking ejector for the 22 long rifle. This started around 1911 according to the catalogs. Usually all of the late model 44 1/2's have the screw including the centerfire rifles. The Trade mark Stevens stamping on the left side of the receiver showed up about the same time.
  
Back to top
 
IP Logged
 
joelpend
Junior Member
**
Offline



Posts: 72
Location: Central North Carolina
Joined: Dec 29th, 2015
Re: stevens 44 1/2 extra scew
Reply #2 - Jun 15th, 2026 at 4:16pm
Print Post  
The little spring loaded plunger works in conjunction with the body of the screw to make it eject vs just extract.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.1716 seconds.