ASSRA Forum › General › Reloading the Single Shot Rifle › I hate casting
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 2 [3]  Send TopicPrint
Very Hot Topic (More than 25 Replies) I hate casting (Read 1624 times)
westerner
Frequent Elocutionist
*****
Offline


deleted posts and threads
record holder.

Posts: 12398
Location: Why, out West of course
Joined: May 29th, 2006
Re: I hate casting
Reply #30 - yesterday at 8:19am
Print Post  
TomKlinger wrote yesterday at 7:39am:
After my many years in the Aerospace industry, I know there is No “repairing” flight hardware or electronics. My years in development and Quality Assurance. Forbids repair. Only replacement or at best “reworking” the defective part. Splices are a big no no unless approved by engineering after the rework has been process written and qualified….. a lengthy process…
Just saying,

PS I don’t mind casting…..

Tom Klinger

 





Same for me Tom. When a reject bullet pops out of a mold I never try to repair it. I just cast a new one. Aerospace industry and bullet casting, who woulda thunk they had anything in common.
  
A blind squirrel runs into a tree every once in a while.
Back to top
 
IP Logged
 
TomKlinger
Senior Forum Member
****
Offline



Posts: 275
Location: Central Florida
Joined: Feb 17th, 2019
Re: I hate casting
Reply #31 - yesterday at 10:27am
Print Post  
westerner,
You got that right!👍😂


Tom Klinger
  
Back to top
 
IP Logged
 
jhm
Frequent Elocutionist
*****
Offline



Posts: 2059
Location: georgia
Joined: Sep 4th, 2011
Re: I hate casting
Reply #32 - yesterday at 3:46pm
Print Post  
You are correct sir. We would remove and replace most of the time but there were rare occasions where we had to dig in there and fix something and yes engineering and quality was always involved in the work.



JMH
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 2 [3] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.3555 seconds.