ASSRA Forum › General › General Discussion › Saying hello
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 [2]  Send TopicPrint
Hot Topic (More than 10 Replies) Saying hello (Read 345 times)
calledflyer
Frequent Elocutionist
*****
Offline



Posts: 3909
Joined: Mar 9th, 2015
Re: Saying hello
Reply #15 - yesterday at 4:48pm
Print Post  
I will take your word, Vall. I didn't mean fitting the first offset barrel, but rather if a repair was made that required setting it back from the original fitting. I looks like getting it just so at that same spot might be touchy, or is it as simple as setting back an ordinary, centered, bore? The fixment pin/screw and extractor look finicky to get just so.  Just askin' Huh
  
Back to top
 
IP Logged
 
slowshot
Junior Member
**
Offline



Posts: 66
Location: Arkansas Hills
Joined: May 7th, 2021
Re: Saying hello
Reply #16 - yesterday at 7:12pm
Print Post  
Hi,  Hildy & welcome  from Arkansas.   have 5 Ballards so guess I will be around for awhile.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1 [2] 
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.2433 seconds.