ASSRA Forum › General › General Discussion › Pioneer molds
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Pioneer molds (Read 254 times)
bnice
Frequent Elocutionist
*****
Offline



Posts: 1936
Location: Iowa
Joined: Nov 30th, 2006
Pioneer molds
Feb 4th, 2026 at 8:41pm
Print Post  
Whose handles did Pioneer use for there single cavity molds
  
Back to top
 
IP Logged
 
stevens52
Full Member
***
Offline



Posts: 231
Location: Fairview,NC
Joined: Jun 6th, 2004
Re: Pioneer molds
Reply #1 - Feb 5th, 2026 at 7:55pm
Print Post  
Saeco handles work on mine.
  
Back to top
 
IP Logged
 
GT
Frequent Elocutionist
*****
Offline



Posts: 2327
Location: Northeast Wyoming
Joined: Jun 28th, 2015
Re: Pioneer molds
Reply #2 - yesterday at 3:19pm
Print Post  
Bob,
I have a couple of Pioneer molds, the only handles that I have that work without any modifications are the Cabine Tree Locking handles.  Even the newer ones from Baco seem to work. 
Greg
  
"To invent, you need a good imagination and a pile of junk"  T. A. Edison
"The trouble ain't that there is too many fools, but that the lightning ain't distributed right" M.T.
Back to top
 
IP Logged
 
bnice
Frequent Elocutionist
*****
Offline



Posts: 1936
Location: Iowa
Joined: Nov 30th, 2006
Re: Pioneer molds
Reply #3 - yesterday at 8:50pm
Print Post  
thanks, Greg, I think the comment without being worked on is the issue. I think either pin holes need opening or arms filed to let pins align. I tried Saeco, Lyman, lee (6 cavity), RCBS and all look like they will work with slight mod to handles.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.6360 seconds.