ASSRA Forum › General › General Discussion › Re: Trim some 405 brass
(Moderator Group: Moderator)
‹ Previous Topic | No Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic Re: Trim some 405 brass (Read 20 times)
KFW
Oldtimer
*****
Offline



Posts: 613
Location: Wyoming
Joined: Dec 18th, 2016
Re: Trim some 405 brass
Jan 29th, 2026 at 11:44am
Print Post  
You need a Harbor Freight 2" chop saw. There are, or was 3d printed jigs for it on eBay. I have done 300 cases on mine.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | No Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 0.3796 seconds.