ASSRA Forum › General › Reloading the Single Shot Rifle › 45-70 and 45-90 neck length
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic 45-70 and 45-90 neck length (Read 103 times)
Bulseyetom
Frequent Elocutionist
*****
Offline



Posts: 1003
Location: Santa Maria, Ca
Joined: Oct 31st, 2010
45-70 and 45-90 neck length
Yesterday at 8:29pm
Print Post  
Dumb but happy. I was wondering how long the straight portion of the case is for the 45-70 and 45-90?  Looking at the case drawings it shows a straight taper from the end but it seems like to get any kind of uniform tension seating a bullet it should have a parallel end for awhile.  Tom Huh
  
Back to top
Twitter  
IP Logged
 
TomKlinger
Full Member
***
Offline



Posts: 210
Location: Central Florida
Joined: Feb 17th, 2019
Re: 45-70 and 45-90 neck length
Reply #1 - yesterday at 10:07pm
Print Post  
It this what you’re talking about?

Tom Klinger
  
Back to top
 
IP Logged
 
Bulseyetom
Frequent Elocutionist
*****
Offline



Posts: 1003
Location: Santa Maria, Ca
Joined: Oct 31st, 2010
Re: 45-70 and 45-90 neck length
Reply #2 - Today at 12:02am
Print Post  
That's it! I would assume that the 45-90 has the same o.400" cylindrical section.  Thanks.  Tom
  
Back to top
Twitter  
IP Logged
 
TomKlinger
Full Member
***
Offline



Posts: 210
Location: Central Florida
Joined: Feb 17th, 2019
Re: 45-70 and 45-90 neck length
Reply #3 - Today at 7:41am
Print Post  
SAMMI and most other reamers do not have the cylinder section. You need to have it cut that way when you order a reamer.
Dan T designed it into all of his match caliber reamers. I use it on all the reamers I order…


Tom Klinger
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2026. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.3084 seconds.