ASSRA Forum › General › General Discussion › 32-35 Stevens reamer
(Moderator Group: Moderator)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send TopicPrint
Normal Topic 32-35 Stevens reamer (Read 90 times)
Babydriver
Full Member
***
Offline



Posts: 191
Joined: Mar 22nd, 2024
32-35 Stevens reamer
Dec 22nd, 2025 at 3:50pm
Print Post  
Don’t know which board to post this so it will be on two for now. 
I have an 1885 low wall in 32 long that I want to change to a 32-35 Maynard Stevens or a 32-20. Looking to borrow if possible a reamer. I won’t do the work but will have an accomplished gunsmith do it.
  
Back to top
 
IP Logged
 
Dellet
Frequent Elocutionist
*****
Offline



Posts: 1216
Joined: May 19th, 2017
Re: 32-35 Stevens reamer
Reply #1 - Dec 22nd, 2025 at 5:18pm
Print Post  
Before you get too deep into this project, check bore size and twist rate. The 32-35 and 32-20 use a different diameter bullet. The 32 long twist rate will probably limit you to around 80-90 grain bullet. If it’s a rimfire, the cost of converting to center fire and re chambering, just to shoot the same bullet, doesn’t make much sense.
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send TopicPrint
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

ASSRA Forum » Powered by YaBB 2.6.12!
YaBB Forum Software © 2000-2025. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge

Page completed in 1.2305 seconds.